EM2X Thermal Panel Printer

EM2X is a 2-inch thermal printer module with auto cutter design, has plug and play capability, Used as panel printer when fixed on an iron plate, and also used as printer module when embedded in other devices, it is widely used in Measuring Devices, Medical Equipment, etc.

Application

  • Portable printers and terminals
  • Handheld terminals
  • Measuring instruments
  • Data terminal devices
  • Medical equipments
  • Taximeters

Exclusive Features 

  • The movable cutter is on the upper side, open the printer to eliminate paper jam, no need to retract the cutter manually required by other traditional structures.
  • With software command to enter standby mode with ultra low standby current(12μA).
  • Use the software command to automatically adjust the heating dots and heating interval time to adapt to the peak current of power supply under different conditions.
  • SAM connector space is applicable for E-Journal or SAM card.

Features  

  • Used as panel printer when fixed on a iron plate,and also used as printer module when embedded in other devices.
  • With stepper motor auto-paper-cutter function, avoid cutter block or TPH burn and lower the designer’s demand.
  • Support Windows
  • Max printing speed:150mm/s(at 12V) 80mm/s(at 8.5V)
  • With high-voltage and low-voltage optional.
  • High printing endurance up to 100km (by using DJ03, Mitsubishi paper or equivalent thermal paper)
  • Compact structure :107*93*105mm.
  • Optional interface: USB,RS232,RS232 TTL
  • SAM connector space inside each is applicable for SD or SAM card (customizable).
Number of dots

384dots/line

Resolution

8dots/mm(203dpi)

Paper entry width (mm)

58mm(Paper width: 57±0.5mm)

Valid printing width (mm)

48mm

Highest printing speed

80mm/s, 150mm/s

Operating

4.2V~8.5, 6V~14V

TPH abrasion resistance

100km(Tested with DJ03, Mitsubishi F230AA)

Cutter

500,000 cuts

Reviews

There are no reviews yet.

Be the first to review “EM2X Thermal Panel Printer”

Your email address will not be published. Required fields are marked *